Whirlpool W11440958 Technical Manual page 31

To Remove the Door Catch Assembly
1. Open door (see Figure 1).
2. Use a TORX T-20 driver to push in on the plastic tab (see
Figure 2).
3. Slide the door catch upward while pulling the bottom of
catch away from the front panel (see Figure 3).
4. Reverse procedure to reinstall.
Figure 1
Figure 2
Figure 3
COMPONENT ACCESS (Cont.)
To Remove the Door "Run/Stop" Pin
1. Open door (see Figure 1).
2. Using a pair of pliers, grasp the "run/stop" pin (used to
depress the door switch paddle) and rotate the pin counter-
clockwise 1/4 turn. See Figure 2.
3. Remove the "run/stop" pin from the door assembly. See
Figure 3.
Whirlpool 24" Compact Condensing Dryer
®
Figure 1
Figure 2
Figure 3
4-3
n