Chapter 9: Part Numbering - Ametek 953N Series Configuration Manual

Chapter 9 - Part Numbering
The Ethernet/IP™ LDT is available in either our 953 Rod Style Package or the 957 Profile package. The numbering scheme listed below will break
down the numbering system for our 953 Rod Style products. The LDT's are available with strokes from 1" to 300" in .1" increments. The "Unit of
Measure" field will allow you to select either inches or millimeters (Note: This is only for the active stroke length of the Rod. The resolution, direction
& counting format are all user defined during the Network set-up process). Since the Rod Style products are typically installed in hydraulic cylinders
the "Mounting Threads Options" field will allow you to match the requested thread to that of the Cylinder.
The "Seal Option" has two choices – X = Standard Buna N or V = Fluoroelastomer. Depending on where these units will be mounted and what
chemicals they may be exposed to, will help determine which option is best for your application.
953N
Model
Rod Style
953N
Profile Style
957N
Insert stroke length to 0.1 inch. Enter as a
four-place number. Example: A 12.0" stroke
enters as 0120.
OR
Insert stroke in millimeters to 1mm. Enter
as a four-place number. Example: 305mm
stroke entered as 0305M.
Phone: 248-435-0700 Toll Free: 800-635-0289 Fax: 248-435-8120 www.ametekfactoryautomation.com
IP 0120 E
Output
EtherNet/IP™
IP
Stroke Length
Units of Measure
Inches
E
Metric
M
S X
Connector Option Options
Standard-2-
X
S
M12D & 1-M12A
Mounting Threads
Blank for 957 Profile style
_
US Threads with raised face hex base
R
US Threads with flat face hex base
F
Metric threads with raised face hex base
M
Metric threads with flat face hex base
N
R X
Seal Options
None
Standard (Buna N)
X
Fluoroelastomer
V
FACTORY AUTOMATION
®
24