Table of Contents
Advertisement
Chapter 7 EtherNet/IP™ Configuration
To configure the PLC and the Ethernet/IP™ you will need to use the
Studio 5000 software. Open the Studio 5000 interface and follow the
steps below:
1. EDS Hardware Install Tool:
Click the Tools menu and select EDS Hardware Installation Tool
2. Register EDS Files: Welcome screen
The EDS Wizard will open, click Next
3. Options Window
In the Options window, select Register an EDS File, then click Next
Phone: 248-435-0700 Toll Free: 800-635-0289 Fax: 248-435-8120 www.ametekfactoryautomation.com
4. Registration: Register a single file
The Registration windows opens, click Browse and select EDS file
downloaded from the www.ametekapt website. Click Next
5. EDS File Installation Test Results
Check ethernet ldt.eds file box below, then hit Next
6. Final Task Summary
The Final task Summary window opens, and displays would you like
ot register the following device, click Next
®
FACTORY AUTOMATION
20
Advertisement
Table of Contents
