Table of Contents
Advertisement
Manual Overview
The ReadyLink™ Network LDT manual will be divided into
two separate manuals, one for Mechanical Installation &
Wiring, and one for Network Configuration. This Network
Configuration manual contains all of the details on how to
configure the Network LDT, establish an IP address and
how to interface into the Host network. For installation,
wiring or specifications please refer to either 953N or
957N Mechanical Installation manuals.
NOTE: Ametek has checked the accuracy of this manual
at the time it was approved for printing. This manual may
not provide all possible ways of installing and configuring
the LDT. Any errors or additional possibilities to the
installation and configuration of the LDT will be added
in subsequent editions. Comments for the improvement
of this manual are welcome. Ametek reserves the right
to revise and redistribute the entire contents or selected
pages of this manual. All rights to the contents of this
manual are reserved by Ametek.
Function of this Document
These operating instructions are designed to address
the technical aspects of commissioning our Ethernet/
IP™ Network LDT into the Host network. Please read
the entire chapter before working with the Network LDT.
These instructions are written for trained personnel
who are responsible for commissioning Ethernet based
sensors into the host network.
Turning on power - Note that the system may
!
execute uncontrolled movement when power
is first applied when the Network LDT is part
of a closed loop system whose parameters have not yet
been configured.
Phone: 248-435-0700 Toll Free: 800-635-0289 Fax: 248-435-8120 www.ametekfactoryautomation.com
Contents
Introduction ................................................................. 3
Chapter 1 Dimensions ................................................. 4
Chapter 2: Wiring Overview. ...................................... 6
Chapter 3: Quick Start ................................................. 8
Chapter 4: EtherNet/IP™ Network Overview ........... 13
Chapter 5: Configuration Data / LDT Memory ......... 18
Chapter 6: Web Server / Page .................................. 19
adapter with Studio 5000. ....................... 20
Chapter 8: LED Summary ......................................... 22
Chapter 9: Part Numbering ....................................... 24
®
FACTORY AUTOMATION
2
Advertisement
Table of Contents
