Configuration Of Analog Sensors; Type 0 - 1/10/30 Volt And 0/4 - 20 Ma - Beko METPOINT BDL Instructions For Installation And Operation Manual

14.2.2.8 Configuration of analog sensors

Short overview of the possible
Except for BEKO-Digital, in this case see Chapter
Digital sensor type) and
The alarm (see Chapter
measuring data), the resolution
Chapter 12.2.2.2 Denoting the measuring data and determining the resolution of the decimal
described in Chapter 12.2.2 Sensor
For the marking of the text fields, see Chapter
14.2.2.8.1 Type 0 - 1/10/30 volt and 0/4 – 20 mA
Main menu  Settings  Sensor settings  C3  Type text field  0 - 1/10/30 V
METPOINT® BDL
Type settings including examples.
12.2.2.6 Dew point sensor with the BEKO-DIGITAL
12.2.2.4 Alarm settings)
of the decimal places and the
settings.
12.2.2.7 Marking and setting text
12.2.2.1 Selection of the sensor type (Example BEKO-
and recording buttons (see Chapter
short name
Scaling of the sensor (here, for example,
type 0 – 10 V - corresponds to 0 – 250°C)
can be found in the data sheet of the con-
nected sensor.
For scale 0 V, please enter the lower scale
value and for scale 10 V
value.
The ext. Sensor supply voltage
on when the sensor requires this.
With the Set-value-to
measured data of the sensor can be set to
a certain value.
The positive or negative difference of the
offset is indicated.
With the reset button, the
reset to zero.
Operation BDL
type.
12.2.2.3 Recording
or the value name (see
places) are all
fields!
the upper scale
is switched
button (offset), the
offset can be
49