Adjusting Back Support Height; Adjusting Back Support Angle; Adjusting Back Support Height (Height Adjustable Push Handle) - Etac Transit Manual

The backrest height is continuously settable (See "The chairs pos-
sibilities").
Loosen the screws (A) Pull the upholstery upwards. Loosen the
nuts (B) and adjust to desired height. Ensure that both sides are at
the same height.
Risk of tipping: Always check the setting of the
the anti-tips.
The backrest angle is settable in fixed positions (See "The chairs
possibilities"). The angle is adjusted using the nut on the inside of
the rear wheel attachments.
Loosen the nut (A), remove the screw and set the desired angle.
Tighten the nut firmly again.
Check that the angle is the same on both sides by
comparing the distance between the back tube and the
armrest plate.
Risk of tipping: Always check the setting of the
the anti-tips.
Adjusting the back support height (height adjustable push handle)
The back support height is adjustable (see "The chairs possibili-
ties"). Loosen the screws (A) Remove the push handle attachment
Loosen the screws (B) and pull the upholstery upwards. Loosen the
nuts (C) and adjust to desired height. Ensure that both sides are at
the same height.
Risk of tipping: Always check the setting of the
the anti-tips.
5. Settings
Setting backrest height
Adjusting backrest angle
A
A
B
+6°
A
0
6
-3
3
-6
B
C
5 mm
-6°
13 mm
3 mm
5 mm
8 mm