Carburetor Disassembly/Reassembly - Honda HRX217K6HYA Manual

HRX217HYA • HRX217HZA

CARBURETOR DISASSEMBLY/REASSEMBLY

• Clean the outside of the carburetor before disassembly.
• The limiter cap is cemented on the pilot screw and should not be removed unless the carburetor is overhauled.
Pilot screw removal is normally not required to clean the carburetor.
 WARNING
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
• Stop the engine and let it cool.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
5 x 6 mm ACCESS SCREW
INSPECTION:
Remove the access screw
to clean the pilot air jet.
ASSEMBLY:
Before installing, clean
thoroughly with low
pressure compressed air
(max. 30 psi).
PILOT AIR JET
(non-removable)
CARBURETOR
INSTALLATION:
Clean internal passages and orifices
with compressed air before installation.
MAIN NOZZLE
ASSEMBLY:
Before installing, clean
thoroughly with low
pressure compressed
air.
MAIN JET
ASSEMBLY:
Before installing, clean
thoroughly with low
pressure compressed
air (max. 30 psi).
#70
MAIN JET NUMBER:
FLOAT
ASSEMBLY:
Check for smooth movement
after installation.
CHOKE VALVE
NOTICE
Tampering is a violation of federal
and California law.
PILOT SCREW
REMOVAL/INSTALLATION:
LIMITER CAP
FLOAT VALVE
ASSEMBLY:
Check for worn float valve seat
and float valve before installation.
FLOAT PIN
SET GASKET
FLOAT CHAMBER
SEALING
WASHER
SET BOLT
FUEL SYSTEM
P. 8-8
VALVE SEAT
FLOAT VALVE
OK
REPLACE
8-7