Valve Clearance Check; Valve Clearance Adjustment - Honda HRX217K6HYA Manual

MAINTENANCE
14. VALVE CLEARANCE
Note
Valve clearance inspection and adjustment must be performed
with the engine cold.
CHECK
1. Disconnect the spark plug cap.
2. Remove the fan cover
3. Remove the head cover bolts, and the head cover.
Note
The cylinder head cover is made of very thin metal and
becomes bent or damaged during removal. If the head cover is
removed, replace it with a new one to prevent oil leaks.
4. Set the engine to top dead center (TDC) of the compression
stroke (both valves fully closed). Rotate the flywheel clockwise
until the magnet inside the flywheel faces the direction of the
cylinder head. This will position the engine at TDC of either the
compression or exhaust stroke. Rotate 360 degrees if
necessary. If it is hard to rotate the flywheel, remove the spark
plug.
5. Insert a feeler gauge between the valve adjusting screw and
valve stem to measure the valve clearance.
VALVE CLEARANCE:
IN: 0.10 ± 0.02 mm
EX: 0.10 ± 0.02 mm
If adjustment is necessary, proceed as follows.
ADJUSTMENT
1. Hold the valve adjusting screw using the special tool (3 mm
wrench) and loosen the valve adjusting screw lock nut.
TOOL:
Valve adjusting wrench, 3 mm 07908-KE90200
2. Turn the adjusting screw to obtain the specified clearance.
3. Hold the valve adjusting screw and retighten the valve adjusting
screw lock nut to the specified torque.
TORQUE:
Valve adjusting screw lock nut: 8 N•m (5.9 ft-lb)
4. Recheck the valve clearance, and if necessary, readjust the
clearance.
5. Apply Hondabond HT or equivalent to the cylinder head cover
installation surface (P.
Installation is in the reverse order of removal.
TORQUE:
Cylinder head cover bolt: 12 N•m (9 ft-lb)
3-12
(P. 7-3).
10-6).
HRX217HYA • HRX217HZA
HEAD
COVER
BOLT (4)
FLYWHEEL
VALVE
ADJUSTING
WRENCH
VALVE
ADJUSTING
SCREW LOCK NUT
To increase valve clearance, screw out.
To decrease valve clearance, screw in.
HEAD
COVER
FEELER
GAUGE
VALVE VALVE
STEM STEM