Control Base/Governor Arm Removal/Installation - Honda HRX217K6HYA Manual

HRX217HYA • HRX217HZA
2. CONTROL BASE/GOVERNOR ARM
REMOVAL/INSTALLATION
Remove the air cleaner and carburetor
GOVERNOR ARM/THROTTLE RETURN SPRING
INSTALLATION:
Install the governor rod through the
throttle return spring as shown.
Connect each to the governor arm and
carburetor throttle arm as shown.
GOVERNOR SPRING
INSTALLATION:
Install with the short end side
toward the governor arm.
CONTROL BASE
BOLT (CT bolt ; 6 x 50 mm)
12 N·m (9 ft-lb)
BOLT (CT bolt ; 6 x 14 mm)
12 N·m (9 ft-lb)
(P. 8-2).
THROTTLE ARM
THROTTLE RETURN SPRING
FUEL VALVE
GOVERNOR ROD
PAINT
GOVERNOR ARM BOLT
SCREW (5 x 10 mm)
2.5 N·m (1.8 ft-lb)
B12 TUBE CLIP
FUEL SYSTEM
GOVERNOR
ARM
GOVERNOR ARM
ADJUSTMENT: P. 3-17
GOVERNOR ARM NUT
3 N·m (2.2 ft-lb) min.
FUEL TUBE
B8 TUBE CLIP
FUEL TUBE
8-5