Muffler Removal/Installation - Honda HRX217K6HYA Manual

MUFFLER
1. REMOVAL/INSTALLATION
 CAUTION
The engine and muffler become very hot during
operation, and they remain hot for a while after operation.
A hot engine or muffler can bun you.
Be sure that the engine is cold before muffler
removal/installation.
SPARK ARRESTER [optional part]
INSTALLATION:
Install after removing the carbon from the
screen with a wire brush.
Inspect for tears or damage.
MUFFLER PROTECTOR
6 x 23 mm BOLT (3)
* CT indicates a self tapping bolt
6-2
4 x 6 mm SCREW
[optional part]
6 x 79 mm BOLT (CT bolt*) (2)
12 N•m (9 ft-lb)
HRX217HYA • HRX217HZA
MUFFLER GASKET
[optional part]
MUFFLER
· Use a plastic hammer to loosen carbon deposits
from the muffler, and then remove carbon deposits
from muffler.
· If the seal flange is dented or damaged, replace the
muffler.
· Do not tap on the muffler seal flange and do not
damage this part.
· Check the cylinder barrel exhaust port for damage.
MUFFLER SEAL
FLANGE
EXHAUST PORT