Advertisement
11.0 Accessories Installation
11.1
3M
™
4327 Series Single-Pair Probes:
a.
Align probe pins with test ports and insert into caps.
Depress clamps to allow clearance over cap heads. Push
probe forward until clamps snap behind cap.
11.2
3M
™
4328 Self-Strip 25 Pair Test Probe
a.
To operate, see instructions with unit.
11.3
3M
4324 Series Self-Strip Priority Circuit Caps:
™
a.
4324- Red- Identifies "hot or special" Circuits
4324B- Brown- Identifies CLEC circuits
b.
Push the priority caps feet between the insides of the self-strip pair cap to identified. The matte surface
of the priority cap allows written identification of the circuit.
3M
™
and MS
2
are trademarks of 3M Company.
IMPORTANT NOTICE
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability
associated with such use.
Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture as of the date of purchase.
3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall
be, at 3M's option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M
will not be liable for any loss or damage arising from this 3M product, whether direct, indirect, special, incidental or consequential
regardless of the legal theory asserted.
Telecom Access Division
3M Telecommunications
6801 River Place Blvd.
Austin, TX 78726-9000
800/426 8688
Fax 800/626 0329
www.3MTelecommunications.com
Printed on 50% recycled paper
with 10% post-consumer
Litho in USA
©3M 2002 78-8122-3167-4
Advertisement
