Table of Contents
Advertisement
Installation and Set-Up
Receiving and Handling
After the applicator has been unpacked, examine it
thoroughly for any damage that may have occurred
during transit. If damage is evident, file a damage
claim immediately with the transportation company
and also notify your 3M Representative.
Machine Set-Up
Read the installation instructions through completely
before performing the set-up procedure. Refer to
the back of this manual for literature on "Typical
Mounting Set-Up" for the S-857 Applicator.
Mounting – The S-857 can be set up in either of
three taping positions:
Bottom Taping Position – Shown in Figure 2-l.
For application of "L" clip tape seal to the bottom
corner of a box.
Top Taping Position – Shown in Figure 2-2. For
application of a tape seal to the top corner of a
box.
Figure 2-1 – Mounting – Bottom Taping Position
Side Taping Position – Shown in Figure 2-3. For
application of a tape seal to the end of a box.
Three mounting areas have been provided on the
S-857 main frame. A mounting bracket (with two
holes) and a single mounting hole on the left side
and two mounting holes located on the front of the
machine. It is suggested that the S-857 be mounted
securely at any two of these mounting areas.
Note: When mounting the unit, always align the
top surface of the nest parallel with the work
surface. When mounting the unit for side taping
align the nest perpendicular to the work surface.
It is suggested that a secondary height adjustment
be provided for head adjustments as referred to in
the top taping operation section.
Note: The air flow control unit must be
remounted in a vertical position when operating
the S-857 in the top or side taping position. All
additional brackets, fittings and air lines are to
be supplied by the customer.
6
Advertisement
Table of Contents
