Feature Programming - Directed Electronics Automate AM5 Installation Manual

Feature programming

The feature programming routine is used to access and change any
of the feature settings in the two menus found on the following pages.
The feature settings can be accessed and changed by using one of the
following:
• The integrated LED/Valet switch to enter the feature programming
routine.
• Use of the Directed Electronics Bitwriter® is recommended. Ex-
panded programming options are only available when using the
Directed Electronics Bitwriter®.
Important:
On, all features are locked and can only be accessed
using a Bitwriter®.
To enter feature programming routine:
1. Open a door.
2. Turn the ignition on and then off.
3. Within 5-seconds, press and hold the integrated LED/Valet switch.
After 3-seconds the horn sounds once to indicate entry to the first
features menu. To select the second features menu, continue to hold
the integrated LED/Valet switch until the horn sounds twice. Once
the menu is selected, release the integrated LED/Valet switch.
4. Press and release the LED/valet switch the appropriate number
of times to advance to the feature you want to change, and then
press and hold the LED/valet switch. The horn honks the number
of times based on the selected feature to confirm the entered rou-
tine.
34
When Feature Programming Lockout is set to
© 2008 Directed Electronics All rights reserved.