Directed Electronics Automate AM5 Installation Manual page 22

H1/9 BLACK/WHITE
Connect this wire to the optional domelight supervision relay.
IMPORTANT! This output is only intended to drive a relay. It cannot be
connected directly to the domelight circuit, as the output cannot support
the current draw of one or more bulbs.
H1/10 WHITE/BLUE
This wire supplies a (-) 200 mA output whenever the button on transmit-
ter programmed for channel 3 is pressed. This output is used to control
optional accessories. This channel can be programmed to provide
the following types of output (see feature programming section of this
guide).
1. A validity output sends a signal as the transmission is received.
2. Second unlock output when the unlock button is pressed a second
time after disarming the system. This can be used to unlock the
passenger doors when installing progressive door locks.
Note:
Zones 2 and 4 are shunted when this channel becomes active.
Zones 2 and 4 re-activate 5-seconds after this output ceases.
Other features can be programmed to channel 3 using the Bitwriter®.
22
(-) 200mA DOMELIGHT SUPERVISON OUTPUT
(-) 200Ma CHANNEL 3 / 2ND UNLOCK OUTPUT
© 2008 Directed Electronics All rights reserved.