Table of Contents
Advertisement
Note: On some vehicles, the security system can be armed using the ignition key for the driver's door
cylinder but can not be disarmed in the same way. The system can only be disarmed using the ignition key
for the driver's door cylinder only if remote start status is active.
Note: The setting for the number of times the Valet switch must be pressed is set in the Feature Programming
section of this guide.
Feature programmming
The feature programming procedure is used to access and change any of the feature settings in the three
menus below. The feature settings can be accessed and changed by using one of the following:
• The integrated LED/VALET® button to enter the feature programming procedure.
• Use of Directed Electronics Bitwriter® is recommended. Expanded programming options are only avail
able when using the Directed Electronics Bitwriter®.
NOTE: If Feature Programming Lockout is set to ON, all features will be locked and can ONLY be accessed
by using a Bitwriter®.
To enter feature programming procedure:
1.
Open a door.
2.
Turn the ignition on and then off.
3.
Within 5-seconds, press and HOLD the Valet® button. After 3-seconds, the siren/horn will
sound once and the LED will flash once to indicate entry into the Menu 1 "Basic User's
Features".
To select the Menu 2 "Advanced User's Features", continue to hold the Valet® button until
the siren/horn sounds twice and the LED flashes twice. Repeat these steps to select Menu
3 "Installer Features". Once the desired menu is selected, the user releases the integrated
LED/VALET® button and then proceeds to the next step.
4.
Within 25-seconds, press and release the V ALET button the number of times corresponding
to the desired feature listed below. Then press the Valet® once more time and hold. The
siren/horn will sound the number of times equal to the feature number selected and the
LED will continuously flash the same number with 2 seconds pause until you move further
to the next step.
5.
While holding the integrated LED/VALET® button, assign the selected feature to a factory
button by either pressing: Lock or unlock for 1 chirp setting (LED ON) or pressing Lock/
Unlock again for 2 chirps setting (LED OFF).
© 2007 Directed Electronics—all rights reserved
21
Advertisement
Table of Contents
