Integrated Led/Valet Switch - Directed Electronics Automate AM5 Installation Manual

➤ Integrated LED/Valet switch

Things to remember when positioning the integrated LED/Valet
switch:
• It should be visible from both sides and the rear of the vehicle, if
possible.
• It needs at least 1-1/2" clearance to the rear.
• It is easiest to use a small removable panel, such as a switch blank
or a dash bezel. Remove it before drilling your 5/16" hole.
Important:
5/16" hole. It is recommened to use a 5/16" drill bit.
Use care to ensure the hole is drilled straight. Drilling at an
angle may cause product malfunction.
10
Do not use a step drill bit (unibit) for drilling the
© 2008 Directed Electronics All rights reserved.