Integrated LED/Valet switch
Things to remember when po si tion ing the integrated LED/Valet switch:
■ It should be visible from both sides and the rear of the vehicle, if possible.
■ It needs at least 1-1/2 inch clearance to the rear.
■ It is easiest to remove a small panel, such as a switch blank or a dash bezel, before drilling a 5/16
inch hole.
Starter kill relay
If the Starter kill relay or its connections are immediately visible when removing the underdash panel, they
can easily be bypassed. Always make the relay and its connections difficult to discern from the factory
wiring! Exposed yellow butt connectors do not look like factory parts, and will not fool anyone! For this
reason, routing the starter kill wires away from the steering column is recommended.
© 2007 Directed Electronics—all rights reserved
9