FINAL DRIVE
9. Rotate bearing by hand and check for smooth
rotation. Visually inspect bearing for moisture, dirt, or
corrosion.
Due to extremely close tolerances and minimal wear,
the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
down movement and minimal movement sideways
between inner and outer race.
10. Replace bearing if moisture, dirt, corrosion, or
roughness is evident.
7.50
NOTE
BEARING REPLACEMENT
Bearing Removal
1. Remove outer retaining ring from the bearing carrier.
2. Support the bearing carrier in an arbor press and
remove the bearing by pressing it out from the back
side.
3. Inspect the bearing carrier housing for scratches,
wear or damage. Replace rear bearing carrier if
damaged.
Bearing Installation
1. Thoroughly clean the rear bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
2. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race or
bearing damage may occur.