ELECTRICAL
REVERSE / MODE BUTTON
Use a multimeter to test for continuity when pressing the
Reverse Override / Mode button. If the test fails, replace
the LH control assembly.
Push the Reverse Override / Mode button. There should
be continuity between pins B and C.
Push the Reverse Override / Mode button. There should
be continuity between pins M (BN) and E (GY/OG).
11.50
HEADLAMP SWITCH
Use a multimeter to test for continuity between the head
lamp outputs in the LH control assembly. If any of the
tests fail, replace the LH control assembly.
There should be no continuity when the switch OFF.
Move the switch to LOW. There should be continuity
between pins D and F.
Move the switch to HIGH. There should be continuity
between pins D and E.
Move the switch to LOW. There should be continuity
between pins YE/DG and DG.
Move the switch to HIGH. There should be continuity
between pins YE and YE/DG.