Battery Installation (Non-High Lifter); Battery Removal (High Lifter) - Polaris Sportsman 850 Service Manual

ELECTRICAL
e
3. Remove the nut retaining the hold-down strap
near the rear portion of the battery and remove the
strap.
4. Disconnect the battery negative (-) (black) cables
first, followed by the positive (+) (red) cables.
CAUTION
To reduce the chance of sparks: Whenever removing
the battery, disconnect the negative (black) cables first.
5. Carefully lift the battery out of the ATV.
BATTERY INSTALLATION (NON-HIGH
LIFTER)
Using a new battery that is not fully charged can
damage the battery, resulting in a short battery life and
can hinder performance. Charge battery before
installation.
1. Position the battery spacer
q
the battery on the spacer.
11.74
NOTE
w
on the frame. Place
r
2. Place the battery into the ATV on its side with the
e
positive (+)
connected in the orientation shown.
3. Coat the battery terminals and bolt threads with
Dielectric Grease (PN 2871329) or petroleum jelly.
4. Connect and tighten the positive (+) (red) battery
cables first, followed by the negative (-) (black)
battery cables.
To reduce the chance of sparks:
Whenever installing the battery, install the negative
Battery Terminal Fastener
5. Install the hold-down strap, cover and retaining nut.
6. Verify cables are properly routed and fasteners are
tight.
7. Reinstall the front rack or storage box.

BATTERY REMOVAL (HIGH LIFTER)

1. Steer the wheels all the way to the left to provide
better access.
2. Remove the negative, then positive, battery cables
from the battery posts.
r
and negative (-) cable terminals
CAUTION
(black) cables last.
TORQUE
6 ft. lbs (8 Nm)