Installation Regulations - Trianco Aztec Mini Installation & Operation Manual

INSTALLATION
INSTALLATION
Regulations
Installation of the boiler must comply with the following British Standards and Regulations:
BS5449 – Forced circulation hot water central heating systems.
BS7074-Part 1: Code of practice for sealed water systems.
The Building Regulations: Part 'L' (Northern Ireland)
Current I.E.E. Regulations
Local water undertaking By-laws.
Health and Safety at Work Act
The installer should be aware of his responsibilities under the Act and provide where necessary, appropriate
protection for persons carrying out the installation. In the interests of safety, a competent engineer should
install the boiler and all wiring must be carried out in accordance with current IEE regulations.
IMPORTANT
ALL ELECTRICAL WORK MUST BE CARRIED OUT BY A QUALIFIED ELECTRICAL ENGINEER TO CURRENT IEE
WIRING REGULATIONS.
UNPACKING THE BOILER
Carefully open the boiler carton, remove boiler and place in a safe place until required.
NOTE: ALWAYS STORE THE BOILER IN A DRY PLACE PRIOR TO FITTING.
SITING THE BOILER
IMPORTANT: NOT TO BE INSTALLED IN A SHOWER
COMPARTMENT OR BATHROOM
Ensure adequate clearance is allowed for making water connections. Access is required to the front of the
boiler for servicing. The boiler must also be fitted in a dry well-ventilated position, which is not subject to
adverse temperature conditions. (See ventilation requirements).
Care should be taken when siting the appliance to make sure adequate access is available for future servicing
of the appliance. Please note that the PCB and heat exchanger assembly may require removal during such
times.
The front cover is held in position by four Phillips Head screws, two at the top and two at the bottom.
Clearance at the top and bottom of the boiler should be adequate to allow access with a small Phillips
screwdriver.
When removing the cover please unplug the cable between the display and main circuit board.
The boiler must be mounted on a suitable wall capable of bearing the weight of the boiler.
Utilise all 6 fixing points on top and bottom fixing brackets.
10