Table of Contents
Related Manuals for Trianco Greenflame 13kW
Summary of Contents for Trianco Greenflame 13kW
- Page 1 Greenflame Wood Pellet Boiler 13-18kW Greenflame Slim Wood Pellet Boiler 13-18kW Installation, Operation and Servicing Instructions Please read these instructions carefully before installing and operating this appliance TO BE RETAINED BY HOUSEHOLDER...
-
Page 2: Table Of Contents
Greenflame Wood Pellet Boiler 13-18kW Contents 1. Introduction 2. Warnings and Guarantee / Warranty Information 2.1 Safety Instructions 2.2 Operating Warnings 2.3 Guarantee / Warranty Information 2.3.1 Limitations 2.3.2 Exclusions 2.4 The Clean Air Act 1993 3. Pre-Installation Considerations 3.1 Pellets 3.2 Considerations for Installation 3.3 Operating Area 3.4 Connection to the Flue... -
Page 3: Introduction
Greenflame Wood Pellet Boiler 13-18kW preparing to operate on the appliance, must have read 1. Introduction and understood the entire contents of this instruction booklet. Dear Customer, All responsibility for improper use is taken entirely by the user and such use relieves T R Engineering Ltd of any We wish to thank you for choosing this Greenflame pellet civil or criminal responsibility. -
Page 4: Guarantee / Warranty Information
Greenflame Wood Pellet Boiler 13-18kW the product. Install the appliance in a location which is suitable for The term “guarantee” is to be understood to denote the free fire-fighting, and equipped with all services such as air of charge replacement or repair of parts recognised to have and electricity supply and provision for discharging been defective at the start by reason of manufacturing combustion gases. -
Page 5: The Clean Air Act 1993
Greenflame Wood Pellet Boiler 13-18kW ENGINEERING LTD DECLARES THAT THE APPLIANCE WHICH with a standard length in the range 5mm to 30mm. Good YOU HAVE PURCHASED COMPLIES WITH EEC DIRECTIVE quality pellets have a density which varies between 2004/108 2006/95/EC SUCCESSIVE 600kg/m and 750kg/m... -
Page 6: Considerations For Installation
Greenflame Wood Pellet Boiler 13-18kW T R Engineering Ltd recommends using certified fuel in its a location where it is able to take in the air necessary for appliances to Enplus-A1. The use of fuel of inferior quality combustion of the pellets (about 40m /h must be available), or not conforming to the specification given above as laid down in the standard governing the installation and in... -
Page 7: Connection To The Flue
Greenflame Wood Pellet Boiler 13-18kW Besides the direction and force of the wind, the position of 3.4 Connection of the Flue the flue and cowl with respect to the roof of the building and surrounding landscape is important. The proper draught conditions in the flue are critical for the The Greenflame air flow regulation system is equipped to efficient working of wood pellet boilers. -
Page 8: Installation And Assembly
Greenflame Wood Pellet Boiler 13-18kW 4. Installation and Assembly been filled with water. Use the template below for constructing the plinth and for positioning the flow and return pipe work and electrical 4.1 Unpacking supply. Refer to service and access clearances around The Greenflame slim pellet boiler will come packaged on a the appliance on Page 10. -
Page 9: Control Panel Schematic
Greenflame Wood Pellet Boiler 13-18kW Only authorised T R Engineering Ltd personnel may open the control panel on the boiler. Any interference with the wiring in the control panel will invalidate the warranty. The boiler and complete plumbing system must be adequately earthed an bonded in accordance with local building regulations and Bye-Laws. -
Page 10: Water Connections
Greenflame Wood Pellet Boiler 13-18kW to a drain to prevent injury to the user or service technicians 4.5 Water Connections if it is activated. All unused connections should be sealed with blanking plugs. A non-return valve should be fitted to prevent back siphonage. -
Page 11: Error Codes
Greenflame Wood Pellet Boiler 13-18kW Er04 – Water over-temperature – Hold button B for 3 seconds. If the problem persists contact your service agent. Er05 – Exhaust over-temperature – Check that the baffles are in position and clean inside the combustion chamber. Er09 –... - Page 12 Greenflame Wood Pellet Boiler 13-18kW Emptying the Ash Pan The boiler contains two areas where ash needs to be removed at regular intervals. The primary ash pan is located in the main combustion chamber. The frequency of emptying the ash pan is determined by the length of time the boiler has been running and under what load conditions.
-
Page 13: Technical Data
Greenflame Wood Pellet Boiler 13-18kW Never allow any foreign material to enter the hopper. This will lead to the malfunction of the auger system and could cause damage to the appliance and invalidate your warranty. Always close the lid to the hopper once it has been filled with pellets. - Page 14 Greenflame Wood Pellet Boiler 13-18kW Flue Height Determined on Site 1150mm 495mm 1100mm...
-
Page 15: Service Log
Greenflame Wood Pellet Boiler 13-18kW Date Service Provided Service Engineer Date Service Provided Service Engineer Date Service Provided Service Engineer Date Service Provided Service Engineer Date Service Provided Service Engineer Date Service Provided Service Engineer Date Service Provided Service Engineer... - Page 16 S35 2PH United Kingdom Tel: 0114 2572300 Fax: 0114 2571419 E-mail: info@trianco.co.uk Web: www.trianco.co.uk ©T R Engineering Ltd Copyright in this brochure and the drawings and illustrations contained in it is vested in T R Engineering Ltd and neither the brochure or any part thereof may be reproduced without prior consent.
Need help?
Do you have a question about the Greenflame 13kW and is the answer not in the manual?
Questions and answers