Explanation Of Test And Data Display - Sega OUTRUN 2 SPECIAL TOURS DELUXE Service Manual

EXPLANATION OF TEST AND DATA DISPLAY


• Do not touch any parts that are not specified in these directions. Touching
unspecified locations may lead to electric shock or cause short circuits.

• In Test Mode, the ride (car body) will move in accordance with the controls. Be
sure that persons other than the conductor of the test are not near the product
while the Test Mode procedures are in progress. Failing to follow this precaution
could result in major or minor collisions or falls.
• Be careful when riding on the ride while operating Game Test Mode. Improper
operation can result in falling. To ensure safety, stand at the bottom of the base
while conducting the ride movement tests.
• Upon exiting Test Mode, the ride will go through the same initialization operation
as when power is turned on. Be careful because the ride will move. There is a
risk of collisions, falls, and fingers being caught.
• Because of the position of the switch unit, you must assume an unnatural posture
to operate Test Mode. This can cause pain in the shoulder, waist, etc. You
could also get caught by parts in the coin chute door, for instance, and suffer
abrasions. Have a flashlight on hand and operate Test Mode very carefully.
The door interior is dark and narrow and you could easily make mistakes in
operation.
• Be careful that a finger or hand does not get caught when opening/closing the
coin chute door.
• When you enter the Test Mode, fractional coin and bonus adder data is erased.
• Adjust the sound to the optimum volume, taking into consideration the
environmental requirements of the installation location.
• Removing the coin meter circuitry renders the game inoperable.