Replacing An Expander Module; Figure 6-8 Install A Power Module - Huawei OceanStor S2600 Manual

6 Replacing Parts
Step 5 Take the power module to be installed from the ESD-preventive bag.
Step 6 As shown in

Figure 6-8 Install a power module

Step 7 Insert the power cable.
Step 8 According to the status of the power running/alarm indicator, judge whether the power module
is successfully installed.
l
l
Step 9 Wait for one minute and then log in to the ISM. Choose the Physical View tab. In the navigation
tree, choose Controller Enclosure to view whether the status of each component is normal.
l
l
----End
Postrequisite
After replacing the power module, mark the removed power module for later handling.

6.7 Replacing an Expander Module

This section describes how to replace an expander module.
6-12
Figure 6-8, insert the new power module in the empty slot.
If the power running/alarm indicator is green, it indicates that the power module is
successfully installed.
If the power running/alarm indicator is orange or is off, it indicates that the power module
may be wrongly installed. Remove the power module and install it again.
Yes: The installation is complete. On the menu bar, choose Alarm > Alarm
Management... to go to the Alarm Management interface. On the Current Alarm tab,
choose Recovery Time. The time for recovering the alarm is displayed.
No: On the menu bar, choose Alarm > Alarm Management... to go to the Alarm
Management interface. According to Advice on the Current Alarm tab, remove the fault.
If the fault persists, contact technical support engineers. For how to obtain technical support,
see 3.4 Obtaining Technical
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Support.
OceanStor S2600 Storage System
Troubleshooting
Issue 03 (2010-01-28)