Table of Contents
Advertisement
Tall Frame Mounting Adapters
The robot can be mounted in a tall frame by installing a set of three frame adapters.
The frame adapters lower the height of the robot by 118 mm.
If used, the lengths of the three mounting bolts will need to be increased by 118 mm.
Cable Inlet Box
The optional cable inlet box can be used to increase the robot's IP rating to IP65.
The part number of the cable inlet box is 08765-000.
NOTE: The cable inlet box is not USDA compliant. Drainage of wash-down
from the cable seal assembly does not comply with USDA requirements.
The cable seal assembly must be mounted on the top of the robot during the robot installation
process. The cable seal assembly is an extra-cost option, and is shipped separately from the
robot. Refer to Installing a Cable Inlet Box on page 55 for more information.
22792-000 Rev. A
Signal
Pin No.
Designation
Pin 1
Pin 10
Pin 19
iX3 565 Robot with EtherCAT User's Manual
Wire Color
Pin 9
Pin 18
Pin 26
Compression Unit
(Compression Wedge, Screw)
CF Frame
Cable Entry
Top Cover
Chapter 1: Introduction
23
Advertisement
Table of Contents
