Chapter 7: Water Circuit Cleaning
Cleaning Procedure
I.
Prepare Sanitizer
Step
In a clean 5 gallon Bucket, prepare 5 gallons of Kay-5 Sanitizer (two 1oz packet of Kay-
5). Use hot water.
Note: Do not exceed 100 ppm Sanitizer strength as this causes damage to the
equipment.
4.
Mix the solution well.
5.
Bring the Bucket to the dispenser.
6.
II.
Sanitize the Pump Kit Parts
Step
Rinse the Tubing Kit Fittings from the Water CIP Tubing Kit in warm water to remove
1.
any debris or soiling.
Place the rinsed Tubing Kit Fittings into the Bucket of Sanitizer.
2.
Classified – Confidential
Action
Action
Page 40 of 46