Cleaning Nozzle And Injector Ring - Coca-Cola Freestyle 7100 User Manual

Hide thumbs Also See for Freestyle 7100:

Table of Contents

page 14 | maintenance

cleaning nozzle and injector ring

How to properly clean the Coca-Cola Freestyle® nozzle and injector ring

Locate the nozzle. Using a clean cloth to protect your fingers, twist nozzle counter-clockwise, and

then pull down to remove.

Scrub the nozzle at a 45° angle with detergent cleanser using the blunt end of the nozzle brush

(small parts #149326).

Rinse nozzle in warm, clean, drinkable water.

Place nozzle in approved sanitizer solution (Kay-5). Shake nozzle tip when submerging to remove

any air bubbles and soak the nozzle for no more than 5 minutes.

OVERNIGHT!

Dip the pointed end of the nozzle brush in sanitizer solution and scrub the injector ring at a 45° angle.

Focus on the small holes where ingredient comes out and the area where the nozzle was connected

(inner ring). To access the interior surfaces of the inner ring, use the wire handle nozzle brush (small

parts #16586). Wipe with a clean cloth and sanitizer and allow to sit for 2 minutes. Then repeat with

clean sanitizing solution.

Allow the nozzle and injector ring area to "AIR DRY," then use a clean cloth to reinstall nozzle and

lock into place turning clockwise.

NOTE:

Take extra care to ensure the nozzle is inserted completely and locked into place.

CAUTION: DO NOT SOAK NOZZLES

Table of Contents

Show Quick Links

Table of Contents