Cleaning Nozzle, Injector Ring, And Ice Chute - Coca-Cola freestyle 7000 User Manual

maintenance

cleaning nozzle, injector ring, and ice chute

How to properly clean
the nozzle and injector ring
Locate the nozzle. Using a clean cloth to
protect your fingers, twist nozzle counter-
clockwise, and then pull down to remove.
Scrub the nozzle at a 45° angle with dish soap
using the blunt end of the nozzle brush (small
parts #149326).
Rinse nozzle in warm, clean, drinkable water.
Place nozzle in approved sanitizer solution
(Kay-5). Shake nozzle when submerging to
remove any air bubbles and soak the nozzle for
a minimum of 2 minutes. CAUTION: DO NOT
SOAK NOZZLES OVERNIGHT!
Dip the pointed end of the nozzle brush (small
parts #149326) in sanitizer solution and scrub
the injector ring at a 45° angle. Focus on the
small holes where ingredient comes out and the
area where the nozzle was connected (inner
ring). To access the interior surfaces of the inner
ring, use the wire handle nozzle brush (small parts #16586). Wipe injector ring with a clean
cloth and sanitizer and allow to sit for 2 minutes. Then repeat with fresh sanitizer solution.
Allow the nozzle and injector ring area to "AIR DRY", then use a clean cloth to reinstall nozzle
and lock into place turning clockwise.
NOTE: Take extra care to ensure the nozzle is inserted completely and locked into place. Test by pouring
a sparkling beverage.
© 2020 The Coca-Cola Company | Coca-Cola Freestyle® 7000 User Guide | Confidential information of The Coca-Cola Company | 20200821 |
How to properly clean
the ice chute
Turn off power using green
power button.
Use the ice chute brush
(small parts #143257) and
approved sanitizer solution
(Kay-5) to clean inside the
ice chute.
Wait two minutes to allow
to air dry, then repeat
step 2 with fresh sanitizer
solution.
Wipe the outside of the ice chute tip using a clean cloth
and fresh sanitizer solution.
Allow time for the ice chute and ice chute tip to air dry.
Return to normal operation.
ice chute brush
#143257
15