Cleaning Nozzle, Injector Ring, And Ice Chute - Coca-Cola freestyle 9000 User Manual

maintenance

cleaning nozzle, injector ring, and ice chute

How to properly clean the nozzle
Locate the nozzle. Using a clean cloth to protect your
fingers, twist nozzle counter-clockwise, and then pull down
to remove.
Scrub the nozzle at a 45° angle with dish soap using the
blunt end of the nozzle brush (small parts #149326).
Rinse the nozzle in warm, clean, drinkable water.
Place nozzle in approved sanitizer solution (Kay-5). Shake
nozzle when submerging to remove any air bubbles and
soak the nozzle for a minimum of 2 minutes.
NOT SOAK NOZZLES OVERNIGHT!
Dip the pointed end of the nozzle brush (small parts
#149326) in sanitizer solution and scrub the injector ring at
a 45° angle. Focus on the small holes where ingredient
comes out and the area where the nozzle was connected
(inner ring). To access the interior surfaces of the inner
ring, use the wire handle nozzle brush (small parts
#16586). Wipe injector ring with a clean cloth and sanitizer
and allow to sit for 2 minutes. Then repeat with fresh
sanitizer solution.
Allow the nozzle and injector ring area to "AIR DRY", then
use a clean cloth to reinstall nozzle and lock into place
turning clockwise.
NOTE: Take extra care to ensure the nozzle is inserted
completely and locked into place. Test by pouring a
sparkling beverage.
14
| © 2020 The Coca-Cola Company | Coca-Cola Freestyle® 9000 User Guide | Confidential information of The Coca-Cola Company | 20200820
CAUTION: DO
How to properly clean the ice chute
Unplug dispenser.
Remove the lower chute by carefully pulling on the front lip
of the power chute. It should disengage and pull forward.
Remove the upper chute by carefully pulling on the upper
lip of the upper chute. It should disengage and pull
forward.
Wash the upper and lower chute and ice chute body area
with approved sanitizer solution (Kay-5) and clean cloth.
Soak upper and lower chutes in approved sanitizer solution
(Kay-5) for 2 minutes. Allow to air dry.
Use a clean cloth and fresh sanitizer to wipe the ice chute
body area. Repeat with fresh sanitizer, then allow to air dry.
Reinstall the upper ice chute by pushing up and into the ice
chute body until a click sound is made. When reinstalling
the upper ice chute, ensure the arrow on outside of ice
chute is pointing toward the dispenser and ice opening.
Reinstall the lower ice chute by pushing up and into the
bottom of the upper ice chute until a click sound is made.
Turn on power to the dispenser, allowing a few minutes for
dispenser to complete standard start-up procedure. Then
test to ensure the dispenser is operating properly, i. e.,
dispense a small amount of ice into a cup.