Prepare The Water Circuit; Connect The Pump - Coca-Cola Freestyle 7000 Cleaning

Chapter 7: Water Circuit Cleaning
III.

Prepare the Water Circuit

Depressurize and purge the water circuits.
Step
In the backroom, turn off the water supply to the dispenser.
1.
Remove the Splash Plate to the front of the dispenser (requires removal of two screws -
2.
one for plate, one for ground wire).
From the Technician UI, select CARB WATER and purge until CO
nozzle. This might take multiple pours, due to time out. The FS7000 carb motor will turn
3.
on and run for two minutes before it times out.
In the backroom, turn off the CO
4.
From the Technician UI, select CARB WATER until CO
5.
system.
From the Technician UI, select PLAIN WATER and purge until no liquid flows from the
6.
nozzle. This should be immediate.
Disconnect the water inlet to the FS7000 carb pump (on the right side) with the quick
7.
disconnect.
IV.

Connect the Pump

Connect the electric pump to the water circuits.
Step
Insert both of the fittings on the ends of the Water CIP Tubing Kit into the Sanitizer.
1.
Classified – Confidential
Action
that feeds the dispenser.
2
Action
gas blows from the
2
gas pressure is relieved from the
2
Page 41 of 46