Analog way HD SCAN XTD920 User Manual page 22

Chapter 11 : RS-232 PROGRAMMER'S GUIDE (continued)
11-4. COMMANDS AND RESPONSES TABLE (continued)
ASCII RESPONSE
COMMAND
STATUS COMMANDS
U UNIT
il ILD
id IFD
ik IST
ip IPS
ih IHP
iv IVP
ii IIN
io IOO
if IFA
GA REFA
GF REFF
GT REFT
NOTE: Rd = Read only command.
PAGE 22
COMMAND
DESCRIPTION
Measures unity in kHz.
This command allows to calculate the
input line frequency in kHz
This command allows to calculate the
input frame frequency in Hz.
Input sync type detection
Input sync detection.
Sign of the horizontal input sync.
Sign of the vertical input sync.
Interlaced signal detection.
Status of the signal in comparison with
the input range frequency.
Input format detection
Status of the synchronization mode
Status of the synchronized format
(genlock).
Frame frequency of the synchronized
signal (genlock) (in hundredth of Hz)
TYPE
MIN MAX
Rd 0 65535
Rd 0 65535 Line frequency (in kHz) = (UNIT VALUE) ÷
Rd 0 65535 Frame frequency (in Hz) = (Line frequency in
Rd 0 3
Rd 0 1
Rd 0 1
Rd 0 1
Rd 0 1
Rd 0 1
Rd 0 1
Rd 0 3
Rd 0 9
Rd 0 65535
Rd/Wr = Read and write command.
VALUE
DESCRIPTION
(ILD VALUE).
Hz) ÷ (IFD VALUE).
0 = separate H & V
1 = Composite sync (TTL)
2 = SOG (Sync On Green)
3 = Composite sync (analog)
0 = no sync detected 1 = sync detected
0 = negative 1 = positive
0 = negative 1 = positive
0 = not interlaced 1 = interlaced
0 = in range 1 = out of range
0 = no signal
1 = "out of range" signal.
2 = VGA1 350l
3 = VGA2 400l
4 = VGA3 480l
5 = SVGA
6 = XGA
7 = SXGA
8 = UXGA.
0 = internal
1 = genlock
0 = no signal 5 = 1035i @ 59.94Hz
1 = "out of range" signal 6 = 1035i @ 60Hz
2 = 720p @ 50Hz 7 = 1080i @ 50Hz
3 = 720p @ 59.94Hz 8 = 1080i @ 59.94Hz
4 = 720p @ 60Hz 9 = 1080i @ 60Hz.
HD SCAN™