Table of Contents
Advertisement
Page 8
Section 4. Install Controller
The controller should be located at or near the
equipment pad, at least 3.5 metres or more away
from the inside wall of the pool/spa, 1.5 metres
off the ground, and within 2 meters of the cell. All
national, state, and local codes are applicable.
4.1
Mount the Bracket
1.
Determine the controller location.
2.
Use the enclosed bracket to mark the
mounting surface through the screw holes.
3.
Drill surface with 7 mm bit.
4.
Install the included wall anchors.
5.
Hang bracket using the included screws.
6.
Hang the controller on the wall bracket and
slide to the right to secure in place.
Figure 5.
Controller Mount
EziSalt Saltwater Chlorinator | Installation Manual
4.2
Electrical Connections
WARNING
FOR YOUR SAFETY: This product must be
serviced by a professional pool/spa service
technician as described on the front cover of this
manual. The procedures in this manual must be
followed exactly. Failure to follow warning notices
and instructions may result in property damage,
serious injury, or death. Improper installation and/or
operation will void the warranty.
The controller must be permanently powered by
connection to a 30 mA residential circuit breaker.
4.2.1
Controller Enclosure Wiring
1.
Wire low voltage connections on the low
voltage side of the enclosure, see Figure 7.
2.
Wire high voltage connections on the high
voltage side of the enclosure, see Figure 7.
3.
Use the internal labels (low voltage - yellow, high
voltage - orange) to identify connection points.
4.
Use the cable ties provided to secure internal
wiring to the controller frame.
5.
Pass cables through the appropriately labeled
strain relief ports. It may be necessary to
pierce the strain relief grommet prior to
passing the cables through it.
Advertisement
Table of Contents
