Section 5. Prepare And Balance The Pool; Water Chemistry Table; Section 6. Operation; User Interface Overview - Zodiac EziSalt Installation Manual

Table of Contents

Advertisement

Page 10
Section 5.
Prepare and Balance the Pool
5.1

Water Chemistry Table

Test and maintain correct water balance throughout the season, according to the table.
Free
Chlorine
Australian
1 -3
Standard
Ideal range
1 - 3
To Increase
Add chlorine or
increase equip-
ment output
To Decrease
In Season
Testing
Weekly
Frequency
*
Fill pool with water from the mains water supply. Do not use rain water or well water.
**
Do not add salt directly into the skimmer. Do not initiate electrolysis until salt has fully dissolved.
***
Reading is True Calcium Hardness, not Total Hardness.
Table 4. Water Chemistry

Section 6. Operation

6.1

User Interface Overview

To avoid to avoid risk of serious damage to the equipment and/or electrocution which could result in serious injury or death, ensure that all salt added to the pool has
completely dissolved before activating the chlorination function of your system.
LED indicates low salt/minerals
or poor water conductivity
Activate
reduced chlorine
production mode
User Menu
Browse current menu;
Increase or decrease a setting;
Lock/unlock the UI (press and hold both)
Figure 8.
Controller User Interface
pH
Total Alkalinity
(ppm)
7.2 - 7.8
60 - 200
7.4
80 - 140
Add buff er or
Add sodium
soda ash (so-
bicarbonate
dium carbonate)
Add muriatic
Add muriatic
acid
acid or dry acid
Weekly
Weekly
Calcium Hard-
Cyanuric Acid
ness (ppm)
100 - 400
***
90 - 300
Add calcium
Add cyanuric
chloride
Partially drain
Partially drain
and refi ll pool*
and refi ll pool*
Weekly
CAUTION
* The filter pump will also operate
if filtration pump is connected to
the controller.
EziSalt Saltwater Chlorinator | Installation Manual
Salt
(ppm)
Level (ppm)
up to 50
4000 - 7000
up to 50
4000 at 27°C
Add salt or
acid
minerals **
Partially drain
and refi ll pool*
Weekly
Monthly
LED indicates information or
error message on screen
On, Off
Standby
mode
Activate 100%
chlorination
for 24 hours*
Enter the highlighted
selection; Delete an
error message
(press and hold
Metal
x
< 0.10 ppm
x
Use 'Metal
Remover'
Monthly
4 seconds)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ezisalt 24Ezisalt 40

Table of Contents