Table of Contents
Advertisement
Invacare® LiNX
5.23 Disabling Bluetooth
The embedded Bluetooth functionality can be disabled when
powering up the system.
1. Press and hold the ON/OFF button for more than three
seconds.
The disabled Bluetooth functionality is indicated by an icon
in the status bar and the status LED inside the ON/OFF
button pulsing for a duration of six seconds.
Bluetooth functionality resumes the next time the system
is powered up again.
5.24 Charging the Batteries
WARNING!
Risk of Injury, Damage or Death
Improper routing of charger cord(s) may cause
tripping, entanglement or strangulation hazard
that may result in injury, damage or death.
– Ensure all charger cord(s) are routed and
secured properly.
– Close supervision and attention is needed when
charging the wheelchair near children, pets or
people with physical/mental disabilities.
Please cycle the power prior to charging if wheelchair
has not been used within 24 hours. This will ensure
the enhanced battery gauge registers the charge to
give an accurate reading during use of wheelchair.
114
1. Plug battery charger into remote's charger socket A.
If remote is powered up, battery gauge indicates that system
is connected to charger by displaying a charge sequence
and then displaying the approximate battery charge state at
the end of charge sequence.
Fig. 5-166
Battery bar displays red
when charge is < 20 %
Battery bar displays orange
when charge is between
20 % and 60 %
Battery bar displays green
when charge is between
60 % and 100 %
1637423-H
Hide quick links:
Advertisement
Table of Contents
