Kenwood NX-3720HG Service Manual page 36

VCO Assist
Tuning point Display
1 L1
2 L2
3 L3
4 C1
5 C2
6 C3
7 H1
8 H2
9 H3
4.3.4 Adjustment item supplement
Adjustment Item Description
LCD Contrast The contrast of LCD display can be
changed.
VCO Assist The lock voltage of VCO is adjusted.
This item must be adjusted before receiver
and transmitter adjustment items.
Frequency Frequency is adjusted under receiving
condition with SSG.
The SSG needs 0.001ppm accuracy so
please use a standard oscillator if
necessary.
This item can be adjusted only in PC Test
Mode so that the adjustment value is not
changed easily.
RTC Correction Real Time Clock is adjusted.
This item uses the internal clock.
(Any measurement equipment is not
required.)
Maximum Transmit Maximum Transmit Power is adjusted.
Power
High Transmit High Transmit Power is adjusted.
Power
Mid Transmit Medium Transmit Power is adjusted.
Power
Low Transmit Low Transmit Power is adjusted.
Power
Ramp Offset Adjust this item to the optimal Ramp
voltage.
Balance The transmit modulation frequency
response is adjusted.
This item is adjusted so that the deviation
of 2kHz becomes the same deviation of
20Hz.
This item must be adjusted before all
adjustment items for deviations are
adjusted.
Maximum Deviation Maximum Deviation of Analog (Wide 5k/
(Analog Wide 5k/ Wide 4k/Narrow) is adjusted.
Wide 4k/Narrow) This item must be adjusted before all
adjustment items for tone deviations are
adjusted.
High Deviation NXDN/DMR high deviation is adjusted.
1-36 (No.RA054<Rev.001>)
RX (MHz) TX (MHz)
136.05000 136.10000
140.80000 140.85000
145.55000 145.60000
150.30000 150.35000
155.05000 155.10000
159.80000 159.85000
164.55000 164.60000
169.30000 169.35000
173.95000 173.90000
Adjustment Item Description
QT Deviation QT deviation is adjusted.
DQT Deviation DQT deviation is adjusted.
LTR Deviation LTR deviation is adjusted.
DTMF Deviation DTMF deviation is adjusted.
Single Tone The deviation of Single Tone used in "2-
Deviation tone" and "5-tone" is adjusted.
MSK Deviation MSK deviation is adjusted.
CW ID Deviation CWID tone deviation is adjusted.
CWID is used to inform the others who is
transmitting on a 6.25-kHz spacing
channel.
(In FCC rule, Analog mode or CWID is
required for each channel-spacing.)
IQ Phase Correction of phase difference shift
between I and Q.
RSSI Reference The minimum RSSI level for scan stop is
adjusted.
Squelch Open The squelch level at level "1" is adjusted.
Squelch Tight The squelch level at level "9" is adjusted.
Low RSSI RSSI display level "
Both "Low RSSI" and "High RSSI" must be
High RSSI
adjusted. (The curve data of RSSI level is
applied.)
" is adjusted.