Kenwood NX-3720HG Service Manual page 31

(5) When removing the TX-RX PCB, then remove the solder of
the antenna hot pin and positive terminal of the DC cord.
Remove the 15 screws from the TX-RX PCB, power
module,and audio amp.
Positive terminal
of the DC cord
Audio amp
TX-RX PCB
(6) Pull it out behind the chassis by rotating the bush <c> of the
DC cord 90 degrees in the direction of the arrow after the
screw <a> in the negative terminal is removed, and the
positive terminal <b> is removed from the chassis.
DC cord
a
b
c c
3.2
(1) Push the upper tabs of speaker holder (stamped mark <1>
Antenna hot pin
Power module
(2) When mounting the panel assembly, pass the flat cable
(3) Fit the panel assembly into the two tabs of the chassis top
Precautions for Reassembly
side) into the front panel first.
Then push the lower tabs (stamped mark <2> side) into the
front panel.
<1> <1>
<2> <2>
There are stamped marks <1> or <2> on
the four corners of the speaker holder.
through the hole of the chassis as shown below then
connect the flat cable to connector of the panel assembly.
Panel assembly
Chassis
side first.
Then, fit the panel assembly into the two tabs of the chassis
bottom side by turning the panel assembly.
Hole of Panel
the chassis assembly
Chassis
(No.RA054<Rev.001>)1-31