Kenwood NX-3720HG Service Manual page 11

2.2.8.2 Data Writing
Before moving to next Zone/Channel, "Keep This Change?"
appears on the LCD, if you select "OK", the new data is written
to memory. If you select "Cancel", the new data not be written;
the new data will be erased.
• The setup items for Front panel programming mode are as
follows.
No. Setup item Display
1 RX Frequency RX Frequency Receive Frequency
2 TX Frequency TX Frequency
3 Channel Type Channel Type
4 Transmit Mode Transmit Mode Analog/NXDN/DMR
*3
5 Channel Channel Space Analog:
Spacing
• Button operation
Button Zone Select
\Item
[ ] Decision
[ ] Unused
[ ] Unused
[ ] Exit panel
program mode
[] Zone change
[] Zone change
[] Unused
[] Unused
MIC Zone number
Keypad select
[0] ~ [9]
MIC Decision
Keypad [*]
MIC Unused
Keypad [#]
Remarks
Transmit Frequency
Analog/NXDN/DMR
12.5kHz/20kHz/25kHz
Note: 20kHz is applied
for E type only.
NXDN:
6.25kHz/12.5kHz
DMR: 12.5kHz
Channel Select RX Frequency TX Frequency Channel Type Transmit Mode
Decision Decision
Back to the Back to the
previous item previous item
Unused Go to the TX
Frequency
Exit panel Exit panel
program mode program mode
Channel change Frequency up
Channel change Frequency down Frequency down Channel type
Unused Frequency step
change
Unused Frequency step
change
Channel number Go to the direct enter mode
select
Decision Decision
Back to the Back to the
previous item previous item
No. Setup item
6 RX Signaling RX QT/DQT
7 TX Signaling TX QT/DQT
8 RX RAN RX RAN
9 TX RAN TX RAN
10 Color Code Color Code
11 Slot Selection Slot Selection
12 Transmit Power Transmit
Power
13 Channel Name Channel Name
*3: In "Channel Type" display, "Transmit Mode" can be
entered only when Mixed mode is selected.
Decision Decision
Back to the Back to the
previous item previous item
Go to the RX Unused
Frequency
Exit panel Exit panel
program mode program mode
Frequency up Channel type
change
change
Frequency step Unused
change
Frequency step Unused
change
Channel number
select
(1,2 or 3)
Decision Decision
Back to the Back to the
previous item previous item
Display Remarks
Receive QT/DQT
Transmit QT/DQT
None, 1~63
None, 1~63
0~15
Slot 1, Slot 2
Low/Medium/High
Channel
*5 Spacing
Decision Decision
Back to the Back to the
previous item previous item
Unused Unused
Exit panel Exit panel
program mode program mode
Transmit Mode Channel
Change Spacing Change
Transmit Mode Channel
Change Spacing Change
Unused Unused
Unused Unused
Transmit Mode Channel
number select spacing select
(1 or 2) *4
Decision Decision
Back to the Back to the
previous item previous item
(No.RA054<Rev.001>)1-11