Check Electrolysis Current; Display Times; Formula And Product Definition - Pentair HAFFMANS c-DGM Instruction Manual

5.4.5 Check electrolysis current

An electrolysis current check is performed to measure the CO
strength for electrolysis measured. Measurement aborted." appears in the case of low
conductivity. If liquids with low conductivity are measured, it is possible to switch off the
electrolysis current test by setting the option "Check E-Current" from "YES" to "NO". When the
electrolysis current test is switched off, the electrolysis time (see section 5.5.3) for the product to
be measured must also be adjusted. This is necessary because liquids with low conductivity
require longer electrolysis times to establish the CO

5.4.6 Display times

During every measurement, the measured values for *O
CO content are shown on the display. The arrow buttons can be used to select and alter the
2
display times. Press "Enter" to return to the "Display times" menu.
Select "Main menu" and press "Enter" to return to the main menu.
5.5

Formula and product definition

The DGM offers the possibility to define a CO
and *package data for each of 10 different products. When the DGM is delivered, all the
products are set to default values. The following steps take you to the product configuration
menu:
1. Press "Enter" until the Haffmans logo appears.
Besides the software version number, the o-DGM serial number is also displayed.
2. Press "Enter" again.
This takes you to the main menu.
3. Use the arrow buttons to select the "Configuration" menu and then press "Enter" to open
the menu.
4. Select the "Formula/Prod.Def." menu on the c-DGM or the "CO
menu on the i-DGM with the arrow buttons and press "Enter" to open the menu.
The currently selected product is shown.
5. The arrow buttons can be used to select the various submenus. Press "Enter" to open
the desired submenu. The product name, CO
stabilization time, *O
You can exit this menu by selecting either the option "Store product" to save the
changes for each product or "Main menu" to exit the menu without saving the changes.
Page 22 of 78
calculation formula, measurement process times
2
sample time and *package data can be defined for each product.
2
, &&D E^ 'D 'D
. The warning "No current
2
equilibrium pressure.
2
, *TPO, temperature, pressure and
2
formula/Prod.Def."
2
formula, electrolysis time, CO
2 2
c-DGM/i-DGM