Advertisement
ALIGN SHOULDER & NOTCH
4-pin receptacle
4-pin connector
Step 2:
Insert the U-bolt from behind the Tank Stand Frame and push through the Mount Plate.
• Use a 7/16" wrench to fasten in place in the following order: U-bolt+[Frame+Mount Plate]+washer+lock nut.
• Securely tighten.
• Repeat on other end of Flow Meter Assembly.
Signal cable connected to Flow Meter
33
Step 3:
Connect the signal cable to the bottom of Flow
Meter Assembly.
• CAREFULLY slide the signal cable into the receptacle.
• Align the receptacle shoulder with the connector
notch (when aligned, receptacle pins will push into the
connector).
• Screw the shield on tight.
Continued
Advertisement
