Advertisement
RH Top View
3' perimeter minimum
!
Warning! Drum band must be removed prior to
running the Drum, to prevent damage to the
Drum!
Plan accordingly!
• Locate the Treater on a solid, flat vibration-free surface and fasten down with anchors.
• The recommended location for all components of the treating system should be on one single floor.
• The Treater must be easily accessible to an electrical power source.
• Allow access to the treater from all sides for the purpose of operation, adjustments, maintenance and clean-up.
!
Caution! Removing Drum band can cause injury! Wear proper personal protective equipment: gloves and
safety glasses. Place one hand on the banding above the cut, while standing to the side of the banding,
as shown above. This will reduce the chance of banding flying out of control, causing injury. Discard used
banding material responsibly.
Step 6:
Use tin snips to cut the metal banding that holds the Drum down onto the Drum Frame during shipping.
Continued
11
Advertisement
