Underwater Lights & Fi Tting The Coping - Procopi ODYSSEA RECTANGLE Installation Instructions Manual

THE UNDERWATER LIGHTS
> >
Figure 53
FITTING THE COPING
> >
Note the distribution of the various modules constituting the coping of your pool,
w
arrange them leaving a gap of approx 10 mm between each two modules and
ensuring an even overlap around the inner periphery of the pool. (+/- 30 mm).
Screw them onto the metal plates using the screws 6x20 (bag G).
w
Clip the junction strips into position (see page 72).
w
Figure 54
Figure 55
To fi nalise installation of the underwater lights, refer
w
to the installation instructions enclosed with the
underwater light and the control panel.
Once the underwater lights have been installed,
continue fi lling the pool until the water level is
2/3 of the way up the skimmer mouth.
POOL 3X6
POOL 4X8
CAUTION
Read the installation
w
manual carefully
and pay scrupulous
attention to
the instructions
concerning wiring. In
case of doubt, call a
professional.
71