Filling The Pool & Cutting Out The Liner - Procopi ODYSSEA RECTANGLE Installation Instructions Manual

»
INSTALLATION INSTRUCTION
ATTENTION
If while fi lling the
w
pool you note that
the liner has been
pulled out of the
track, stop fi lling
before reengaging
it. You may have to
partially empty the
pool before you will
be able to rehang
the liner.
Repositioning of
w
the liner by sliding
it along the track
is prohibited, this
could cause the liner
to tear. Release the
liner then reposition
it.
Refer to the
w
additional
installation
instructions
provided with the
various fi ttings.
70
/ RECTANGLE
FILLING THE POOL & CUTTING THE LINER
> >
At this point, mark the position of the holes in the pool fi ttings through the liner and mount
w
the various fl anges. Don't forget to apply the second gasket to each fl ange before screwing
it into position.
Figure 46
Flanges on the return fi tting and vacuum point: mark the screw holes. Apply the
w
second gasket. Screw into position (pozi countersunk head screws TFZ M5x16 from
the Pool Fitting skin). Tighten screws alternately and moderately by hand.
Figure 50
Proceed in the same way to fi t the skimmer fl anges.
w
Figure 52
Figure 47
Figure 51
Next, using a Stanley knife, cut the liner inside the
w
fl anges.
Figure 48