Ladders - Procopi ODYSSEA RECTANGLE Installation Instructions Manual

THE LADDERS
> >
Figure 61
Assemble the various parts of the stainless steel ladder referring to the installation
w
instructions provided. When mounting the hand rails, do not forget the two rubber
seals that will be used to hold the decorative escutcheon plates in position.
Position the ladder in the pool on the coping module of your choice (but not against
w
the wall holding the skimmer and counter swim module), remember that it should be
opposite the wooden ladder.
Adjust the position of the ladder paying particular attention to ensure that it is vertical
and that the bumpers are pressed fi rmly against the inside wall.
Mark the positions for drilling. Remove the ladder and drill.
Fix the ladder in place according to the instructions provided, the counter plate
should be positioned under the coping (additional bag in the Filtration pack). Tighten
moderately.
Slide the 2 rubber seals along the tubes so that they hold the escutcheon plates in
position.
Figure 63
Assemble the wooden ladder as illustrated, use screws from bag (K)
w
The wooden ladder is held in place by hooks attached under the coping and a lever
w
mechanism attached to the saddle of the ladder. The fastening mechanism may differ
from that illustrated but will function according to the same principle.
Figure 65
Figure 62
O-RING
ESCUTCHEON
PLATE
FLANGE
COUNTER
PLATE
Figure 64
Figure 66
CAUTION
The wooden ladder is
w
a safety element. Do
not forget to remove
it after bathing!
Apply the self-
w
adhesive label
recalling this
instruction to the wall
of the pool !
73