Pool Fi Ttings - Procopi ODYSSEA RECTANGLE Installation Instructions Manual

»
INSTALLATION INSTRUCTION
Figure 32 A
Figure 32 C
CAUTION
When fastening
w
pool fi ttings in
position, avoid
overtightening the
screws as this could
crack the fi tting.
Hand tighten by
preference.
Make sure that
w
the gaskets are
correctly positioned
and applied. It
will be diffi cult to
correct mistakes
made after the liner
is fi tted.
62
/ RECTANGLE
POOL FITTINGS (SKIMMER)
> >
Skimmers
First, mount the skimmer prefi x fl ange using the slotted countersunk head wood
w
screw) screws (VB FZ) 3x25. You will fi nd these components in the Pool Fitting
skinpack.
Attach the grey tube L.325 (see page 65 ref l10) to the body of the skimmer, then,
working from outside the pool, put the skimmer in position taking care to position
it fl at against the prefi x fl ange. Hold it in place with the pozi countersunk head (TFZ)
screws M5x16 + nuts and washers. Stick the fi rst self-adhesive gasket (Pool Fitting
skinpack) to the front of the skimmer. Take care to ensure that the holes line up
correctly.
Nozzle bodies
Figure 33
Working from inside the pool, fi t the 3 throughwall fl anges (Pool fi tting skin pack) for
w
the 2 return fi ttings and the vacuum point into the pre-drilled apertures. Fix them in
position using the slotted countersunk head wood (VB FZ) 3x25 screws.
Apply a fi rst self-adhesive gasket to each throughwall fl ange.
w
Figure 32 B
Figure 32 D
Figure 34