Table of Contents
Advertisement
Lower the filter into the water, lean it over slightly to evacuate any air trapped in the filter body, then position
it in one corner of the TROPIC JUNIOR pool, clipping it onto each side of a corner block (213).
5.4
Installing the pine coping
205
×4
101
×24
Arrange the coping slats on top of the walls and
adjust their position so that they come together
perfectly in the corners. The inner edge of the coping
should overlap the pool by approximately 15 mm.
Fasten the coping in position using 6 screws per
coping slat: two at each end of the coping slat (205)
and one at each of the vertical braces (208).
Push the suction pads against the liner to hold the
filter in place. If the filter is inclined to rise to the
surface or turn over, make sure that is does not
contain any trapped air. It may be necessary to add
a few centimetres of water.
Position the pup cable in a corner, between the
ends of two sections of liner locking track. Caution,
once the coping slats have been fixed in position,
you will not be able to change the location of the
cable without first unscrewing the coping slats.
2017/04 - Indice de révision : A - Code : 37411
17/24
Advertisement
Table of Contents
