Finishes & Apertures - Procopi ODYSSEA RECTANGLE Installation Instructions Manual

FINISHES AND APERTURES
> >
Figure 30
Glue the 8 polystyrene elements
w
(enclosed in the filtration package)
into each corner of the pool. 4
will need to be trimmed to the
size of your pool. Use a glue that
is compatible with the materials
involved.
UNDERWATER LIGHTS
> >
Your pool comes with 2 underwater lights that may be freely positioned. The ideal position
w
would be each third of the way down one length of the pool at about 60/65 cm from the
top of the wall.
At this point, you will need to make 20cm diameter holes at the positions selected. These
steps, that must be carried out before the liner is fitted, are set out in the installation
instructions provided with the underwater lights. Pay particular attention to the application
of the waterproofing gaskets.
Figure 31
Cover the vertical joins in the wall with
w
a strip of adhesive tape (roll enclosed in
the liner/waterproofing kit), make sure
that screw heads are covered.
CAUTION
The holes for the
w
underwater lights
must be made before
the liner is fitted.
By preference, work
w
from inside the pool
making sure that
the hole is made
perpendicular to the
wall.
61