October 2007
Sensors
ANALOG SHIELD
ANALOG SHIELD
2-2
Connect the dew point sensor cable to the 25-pin connector on the
OptiSonde's rear panel (see Figure 2-2 below). Connect the optional
temperature sensor cable to the 9-pin temperature connector on the
rear panel. Other I/O wiring connects to the appropriate terminal
block. Tighten all connector thumbscrews to prevent disconnections.
Figure 2-2: OptiSonde Benchtop Rear Panel
Figure 2-3: OptiSonde DC Option Rear Panel
RELAY SHIELD
RELAY SHIELD
Installation