Axis 5570e User Manual page 48

Setting Up - IBM Mainframe (zSeries)
Notes:
48
21. Set Default LU type to Printer (LU type 1 or 3).
22. Specify the VTAM LU name prefix. Click OK.
• When the LUs are created the default names for the Printer Devices will be <name prefix>
followed by a two digit number starting at the number you entered in the starting depen-
dent LU number field.
• In the example below, eight LUs are created automatically. The LU names created will be
BRLTST04 through to BRLTST0B. These names must correspond to the Printer Names you
specify for the TN3270E sessions in the Print Server.
You can now generate a configuration report from NW for SAA. To do
this, simply mark the server icon in the left window and select
Generate Server Configuration Report from the function
menu.
The following table is a summary of a report generated by this command
for the example above.
Profile Name
SNA Network ID:
Peripheral node control point name:
Block ID/PU ID:
Local/Partner SAP for ILUs:
Logical Adapter:
PU Profile:
Adapter Name
Adapter Type:
Terminate peer link if no active APPC sessions:
Logical adapter number:
Number of local service access points:
Enable adapter at startup:
PU Profile Name
Number of dependent LUs:
Starting dependent LU number:
Peripheral node control point name:
Node ID (block/PU ID):
Offline test mode:
Assign only LUs activated by the host:
Enable SDDLU Support:
Adapter Name:
Adapter Type:
Maximum Session Count:
VTAM Name Prefix:
Default LU Type:
Default Model Number:
Default LU Category:
Maximum frame size to transmit inbound:
Remote node address:
Remote Service Access Point:
Local Service Access Point:
Enable PU profile at startup:
NWSAA
SEEDB
CPNAME
05D 66204
04
E100B_1
NWSAAPU
E100B_1
LLC 802.2
No
0
2
Yes
NWSAAPU
NWSAAPU
No
Yes
No
E100B_1
9
BRLTST
1
2
Public
020066800000
04
Yes
AXIS 5570e / AXIS 5670e User's Manual
8
4
05D 66204
LLC 802.2
0521
04