Changing The Quickfit Bands; Extra Long Diving Band; Metal Watch Band Adjustment; Descent T1 Device Care - Garmin DESCENT MK2I Owner's Manual

Changing the QuickFit Bands
®
1 Slide the latch on the QuickFit band, and remove the band from the watch.
2 Align the new band with the watch.
3 Press the band into place.
NOTE: Make sure the band is secure. The latch should close over the watch pin.
4 Repeat steps 1 through 3 to change the other band.

Extra Long Diving Band

Your device comes with an extra long band you can wear over a thick exposure suit.

Metal Watch Band Adjustment

If your watch includes a metal watch band, you should take your watch to a jeweler or other professional to
adjust the length of the metal band.

Descent T1 Device Care

NOTICE
Do not grip the regulator or the transmitter to move, carry, or adjust the air tank.
Do not remove the safety plug from the base of the transmitter.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to chlorine, salt water, sunscreen, cosmetics,
alcohol, or other harsh chemicals. Prolonged exposure to these substances can damage the case.
Avoid extreme shock and harsh treatment, because it can degrade the life of the product.
Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause
permanent damage.
Discontinue use if the device is damaged or if it is stored at a temperature outside the specified storage
temperature range.
Discontinue use if there is water ingress into the battery compartment. Even small amounts of water can cause
corrosion of the electrical contacts.

Cleaning the Transmitter

1 After each dive, rinse the transmitter with fresh water to remove salt and debris.
2 If necessary, clean the transmitter with a soft cloth.
130 Device Maintenance