安裝衣襬尺寸導引器 / Welt Guide Installation - Siruba 700K Manual

1. 安裝衣襬尺寸導引器 /
A.左右調整將左邊的可撇式導板和落針處中心線對齊。
Making a left or right adjustment, to align the left side of the retractable guide with the center line of the needle.
B.前後調整可將可撇式導板尾端對齊切刀。
Making a forward or backward adjustment, to align the end of the retractable guide with the
cutter.
C.調整可撤式導板座高度 / Adjusting the height of retractable guide base
⑴如圖所示，放鬆螺絲以調整可撤式導板座。
Loosen the screw to adjust the retractable guide base as shown in the figure.
⑵可撤式導板座應和針板平行並間隔 0.03mm。
The retractable guide base should be parallel to the needle plate with a 0.03mm clearance.

高度調整螺絲
Height adjustment screw
Welt Guide Installation
Center of the needle
可撒式導板
Retractable guide
前後調整螺絲
Front-to-back
adjustment screw.
針中心
對齊
Line to align with
1